![]() I'm hoping with now having 2 battery packs installed I will get a year of service, if not I guess I'll be buying that AA conversion kit and running AC to my meter pit. I'm guessing the difference was in alkaline vs lithium. These batteries were installed on Feb 8th and yesterday I started receiving low battery warnings. The battery pack is wired in Parallel which keeps the voltage at the 3 volt level, the equivalent of 2 AA batteries but doubles the amp hour capacity.Īnother interesting fact is that I replaced the black battery pack with 4 new Energizer alkaline batteries until the replacements arrived. Nothing that could be easily hacked unlike the black holder which the batteries can at least easily be replaced. What I found inside was 4 batteries in a plastic tray and the battery contacts contained allot of soldered connections between the positive and negative terminals. ![]() I ordered this kit which contains Torx drivers, T1 through T10. I likewise agree the grey battery pack is a waste of money. My Flume also came with the black holder and the batteries were wrapped with a black plastic. I also ordered the new battery pack and they sent me one under warranty. I literally just went through the exact same thing yesterday. Kicker is you need an outlet near your flume - I installed an outlet near my meter a while ago in anticipation of putting a z-wave shutoff valve in on my main line, so I was lucky there. I tested my new "battery package", and it was putting out ~3.4v, which matched the output of the original config w/ 4 lithium AA,īuttoned it all up and put everything back in place, and it's working great so far! The 2-AA conversion kit seems to work great - I just loaded the powered battery and its dummy battery in the lower 2 slots of the black battery pack - I left the other two slots empty. The Flume wants ~3 volts (they new grey battery pack even says "3V" on it). The diference is the voltage - the 4-AA kicks out ~6 V, and the 2-AA kicks out ~3v. Knowing it was 4 AAs, I originally ordered a 4-AA conversion kit - that was another mistake! In actuality, it needs this 2-AA conversion kit. I'm left to conclude those grey boxes ain't gonna open.īut fortunately my Flume 2 came with one of the older black/open-construction battery packs that just had 4 lithium AA batts in it - easy to work with! I tried mashing all of my various micro screwdriver tools (various phillps and star-nut types), but nothing would grip. 03 gallons per minute or around 1 gallon per hour which would be close to 152 drips (assuming 15,140 drips in a gallon) of water per minute without needing to invasively cut and splice the Flume into your plumbing. There are two "pins" holding the top and bottom half together, but they are tiny and appear to be rivets. Somehow Flume reads the magnetic field of your water meter allowing it to detect, they claim, as low as. You'd have to literally break it open to see what's inside. Update on my quest to get Flume on mains power.įirst, I ordered one of those new grey battery packs out of curiosity - it was a waste of $20.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |